Filter
Top Products
How to Vacuum Package Using FoodSaver
Bulk Storage and Square Canisters
THE FOODSAVER USER MANUAL
16
THE FOODSAVER USER MANUAL
17
7 Lock the lid by pulling the locks
forward on both sides until they
snap into place. (You may need to
press down lightly on the stars
while pulling the locks forward.)
8 Press and release the On button.
The lights will turn on in sequence
as the Vac 1050 starts the vacuum
cycle and air is removed from the
canister. The sound will stop and
the lights will turn off when
vacuum packaging is complete.
9 Turn the knob on the canister lid so the arrow points to “Closed.”
10 Vacuum packaging is complete.
How to Open the FoodSaver Bulk Storage or Square Canister
To open the FoodSaver Bulk Storage or Square Canister, turn the
knob on the canister lid so the arrow points to “Open.” This will
release the vacuum and you should be able to remove the lid.
NOTE: Do NOT attempt to vacuum seal any contents that are
warmer than room temperature, since the vacuum may cause
the contents to bubble out of the canister or jar.
IMPORTANT: Remember to remove the accessory hose from the
accessory port on the Vac 1050 before you vacuum package in
FoodSaver Bags.
FoodSaver Bulk Storage and Square Canisters are a great way to
store food in your refrigerator and pantry. The Square Canister is
also ideal for marinating.
FoodSaver Canisters cannot be stored in the freezer. The Bulk
Storage and Square Canister bases can be used in the microwave
to reheat foods and put in the dishwasher for cleaning. Do not
put the lids in the microwave or dishwasher.
1 Place the Vac 1050 on a flat, dry surface and plug the power cord
into a standard electrical outlet.
2 Place the item(s) to be vacuum packaged inside the canister. Leave
at least one inch between the contents and the rim of the canister.
3 The canister lid is labeled “Open,”
“Vacuum,” and “Closed.” Turn the
knob on the canister lid so the arrow
points to “Vacuum.”
4 Place the lid on top of the canister.
5 Insert one end of the accessory
hose into the accessory port on the
Vac 1050.
6 Insert the other end of the acces-
sory hose into the hole on the top
of the canister.