Tricity Bendix SE210/1W Cooktop User Manual


 
17
LEVELLING
Fix the support with two legs with the washer
and nuts, delivered with the cooker, see the
figure.
Unscrew the legs as far as possible
(approx. 16mm from fully screwed in).
Place the plinth (pos.3) so that the springs
(pos.2) reach the threaded area of the
legs and the clamp of the plinth (pos.4) is
in front of the holes (pos.5) on the under
side of the structure.
Push the plinth towards the appliance with
both hands until the springs fasten on the
legs and the clamps go into the
corresponding holes.
Adjust the legs as necessary.
1
3
2
5
4
ELECTRICAL CONNECTIONS
Any electrical work required to
install this hob and the supply cable
should be carried out by a qualified
electrician or competent person, in
accordance with the current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any
liability should these safety measures not
be observed.
Before any maintenance or cleaning
can be carried out, you must
DISCONNECT the cooker from the
electricity supply.
This cooker is designed to be connected to a
230-240V AC, 50Hz electrical supply.
To connect to the electricity supply, use cable
type H05 RR-F.
Before connection, make sure the electricity
supply voltage is the same as that indicated
on the rating plate.
The cooker is supplied without supply cable.
A flexible supply cable must be fitted, in
accordance with the specification given in
the relevant table no. 1.
The electrical connection should be made
using a double pole-isolating switch (cooker
control switch) with at least 3mm contact
separation in all poles. The cable must have
conductors of sufficiently high cross-
sectional area to prevent overheating or
deterioration.
The switch should be sited within 2m of the
cooker and be easily accessible at all times.
The switch must not interrupt the yellow-
green earth wire.