True Manufacturing Company TCGR-77 Refrigerator User Manual


 
............ www.truemfg.com ............
True Food Service Equipment, Inc.
12 12
INSTALLATION / OPERATION INSTRUCTIONS
FORMICA KIT INSTALLATION:
FORMICA KIT COMPONENTS:
(2) Formica Top End Panels 10
3
/4"w x 33"h
(27.3 cm x 83.8 cm).
(2) Bottom End Panels
(1) left side, (1) right side (Formica glued to
black plastic panel with 4 key hole slots).
(1) Formica Front Panel
width will vary x 7
5
/8"h (19.4 cm)
NOTE
Please use care when installing the Formica.
Formica can chip, crack, or break.
NOTE
Refer to image 1 for placement of Formica panels.
A. Install the front Formica panel.
Be sure bottom end panels are off in order to
install front panel. Slide front panel into top
and bottom tracks on the front of the cabinet.
Make sure panel is even on both left and right
end of the cabinet (images 1 & 2).
B. Install the top end Formica panels (one on
each side.
Be sure bottom end panels
are off in order to install top
end Formica panel. Both
top end panels are the same
size so they each can be used for
left or right of the cabinet.
Slide panel up into black plastic tracks on the
top side panel of each end of cabinet (images
1 & 3).
NOTE
After installing the bottom end pieces the top end
panel will stay in place.
C. Install the bottom end Formica panels (one on
each side.
(Formica is pre-glued to black plastic panel).
Line up the four keyhole slots in each bottom
end piece to the (4) screws on the side of the
cabinet. Slip the (4) large keyholes from the
bottom end piece over the (4) screws. Then
push down to fasten the bottom end piece
onto the cabinet (images 1 & 3).
NOTE
The bottom left and right pieces are not the same.
The taller part of the bottom end piece goes to the
rear of the cabinet as shown in image 3.
OPTIONAL (INSTALLING OPTIONAL FORMICA KIT)
3
1
2
Four keyholes
on backside.
Formica top
end panel
will slide up
into plastic
tracks.
Formica top
end panel
will rest on
screw.
Formica bottom
end panel will lock
through keyholes on
backside of bottom
end piece.
STEP A
Side view of Formica sliding
into place for front panel and
top end panel.
STEP C
STEP B
STEP A
Tracks to
hold Formica.
Formica.