Filter
Top Products
8 CLR2160, CLRCO2175
Temperature Control
Checking Product Temperature
Figure 4
To check the actual product temperature, in refrigerator
section only, insert an accurate thermometer into a plastic
(non-breakable) bottle that is partially filled with water.
Tighten the bottle cap securely (Figure 4).
Place the bottle in the refrigerator area for 24 hours.
Refrain from opening the unit during the testing period.
After 24 hours, check the temperature of the water. If
required, adjust the temperature control in a small
increment (See ADJUSTING TEMPERATURE).
Factors which affect the internal temperatures of the
cabinet include:
• Temperature setting.
• Ambient temperature where installed.
• Number of times and length of time the door is
opened and closed.
• Installation in direct sunlight or near a heat source.
Interior Lighting
The interior of Model CLR2160 is not illuminated. The
refrigerator section of Model CLRCO2175 is illuminated
whenever the door is opened.
The LIGHT icon (Figure 3, 5) on the control panel is used
to control an additional Model CLRCO2175 lighting
function. The blackout/Sabbath mode (not Star K
certified) will turn the interior light and display (Figure
3, 3) off.
To access the blackout/Sabbath mode (not Star K
certified):
1. Touch and hold the LIGHT icon (Figure 3, 5) for ten
seconds and release (the °F symbol will flash briefly at
the end of the five second period).
2. The interior light and control display
(Figure 3, 3)
will
go dark for 36 hours.
NOTE: Although the display will not be visible, the
temperature controls in the unit remain active, and the
interior temperature will be maintained.
3. To exit the
blackout/Sabbath mode (not Star K
certified) before the 36-hour period
, repeat Step 1.
Electronic Control Panel
Figure 5
The electronic control with digital display (Figure 5) is
configured to show a single temperature continuously.
This set-point temperature is a base number used by the
controller to maintain the temperature zone in your unit.
The factory default set-point is 38°F. This set-point
temperature is used as a gauge if further temperature
adjustments are required.
Temperature Display Selection
U-Line products supplied for 110 VAC operation have
temperatures displayed in a default Fahrenheit (°F)
configuration (Figure 5, 3). Models supplied for 220 VAC
operation have temperatures displayed in a default
Celsius (°C) configuration.
The display can easily be adjusted for either type of
temperature display. Press and hold the LIGHT icon
(Figure 5, 5) and within five seconds press the COOLER
icon (Figure 5, 4) three times to change the display as
desired.
ULIN_0093_A
123 54
ULIN_0058_A