Verona VEFSGE 304 SC.. Range User Manual


  Open as PDF
of 24
 
20
3
3-Wire Power Cord Installation(SeeFigure3.2)
1. RemovetheTerminal Block Access Plateonthebackofthe
rangebyunscrewingthe4xingScrews(Figure3.1).
2. CheckthecorrectpositioningofthePower Cord Bracketas
pergure3.2.
3. AssemblethestrainreliefintheholeonPower Cord Bracket.
4. InsertthePower Cordthroughthestrainreliefandtighten.
5. Removethe3wireterminalnutsandwashersfromtheTermi-
nal Block.
6. PlugtheterminalholesofPower Cord.
TheNeutral or Ground WireofthePower Cordmustbecon-
nectedtotheneutralterminallocatedinthecenterofTerminal
Block.
The Power Wiresmustbeconnectedtotheoutsideterminals.
7. Plugwashersandtightennutssecurely.
DonotremoveGround strap.
8. ReassembletheTerminal Block Access Plateonthebackof
therangebyscrewingthe4xingScrews(Figure3.1).
4-Wire Power Cord Installation (SeeFigure3.3)
1. RemovetheTerminal Block Access Plateonthebackofthe
rangebyunscrewingthe4xingScrews(Figure3.1).
2. CheckthecorrectpositioningofthePower Cord Bracketas
pergure3.3.
3. AssemblethestrainreliefintheholeonPower Cord Bracket.
4. InsertthePower Cordthroughthestrainreliefandtighten.
5. Removethe3wireterminalnutsandwashersfromtheTermi-
nal Block.
6. RemovetheGround Strapfromtheframeofrangeandtermi-
nalbyremovingitsscrewandcuttingitasshowninFigure3.3.
7. PlugtheterminalholesofPower Cord.
TheNeutral WireofthePower Cordmustbeconnectedtothe
neutralterminallocatedinthecenterofTerminal Block;the
Power Wiresmustbeconnectedtotheoutsideterminals;the
Ground Wiremustbeattachedtotheframeofrangebyusing
the(Ground)identied
Grounding Screw.
8. Plugwashersandtightennutssecurely.
9. ReassembletheTerminal Block Access Plateonthebackof
therangebyscrewingthe4xingScrews(Figure3.1).
Terminal Block
Ground strap
Neutral Wire
Power Wires
Power Cord
Power Cord
Bracket
A: D=1” 9/64 (29 mm)
B: D=7/8” (22.5 mm)
A
B
Terminal Block
Cut Ground Strap
Power Cord
Bracket
Neutral Wire
Power Wires
Grounding Wire
Grounding
Screw
A: D=1” 9/64 (29 mm)
B: D=7/8” (22.5 mm)
Power Cord
A
B
Terminal Block
Access Plate
Screws
Screws
Fig. 3.1
Fig. 3.2
Fig. 3.3
 previous next