Filter
Top Products
— 18 —
F35628 (10-04)
TROUBLESHOOTING GUIDE
SYMPTOM
Indicator light fails to light
when power ON/OFF
switch is set to ON
position
Indicator light fails to go
out when power ON/OFF
switch is set to the OFF
position
Griddle does not heat
when thermostat is turned
on
Igniter stays on too long
after pilot flame is
established
Igniter fails to light
CAUSE
Not plugged in
Faulty ON/OFF switch
Store circuit breaker tripped
Faulty lamp
Faulty power ON/OFF switch
Not plugged in
Faulty ON/OFF switch
Store circuit breaker tripped
Faulty thermostat
Problem with pilot valve
Problem with igniter
Problem with flame switch
Loose wire connection
Flame switch has not had enough
time to heat up
Flame switch bulb not hot enough
Problem with igniter
Unit not plugged in
Store circuit breaker tripped
Problem with power ON/OFF switch
Loose wire connection
REMEDY
Plug griddle into correct voltage
outlet
Replace ON/OFF switch
Reset circuit breaker
Replace lamp
Replace switch
Plug griddle into correct voltage
outlet
Replace ON/OFF switch
Reset circuit breaker
Replace thermostat
Check operation of pilot valve
Check operation of igniter
Check operation of flame switch
Check for bad connection and
correct
Allow more time for flame switch to
heat up
Check alignment of pilot and flame
switch
Check for obstruction or wrong size
orifice
Check for proper gas pressure
Replace igniter
Plug griddle into correct voltage
outlet
Reset circuit breaker
Replace ON/OFF switch
Check and repair wire connection