Filter
Top Products
— 5 —
F35628 (10-04)
CONTROL PANEL
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AND
FOLLOW LOCKOUT / TAGOUT
PROCEDURES.
1. Remove the two screws securing the
control panel. One screw is located at
each end of the control panel.
2. Pull the control panel forward and
disconnect the electrical connector near
the right end.
Figure B
3. Reverse the procedure to install.
COVERS AND PANELS
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AND
FOLLOW LOCKOUT / TAGOUT
PROCEDURES.
Bullnose Weld Assembly
1. Remove control panel.
2. The bullnose weld assembly is secured
with two screws, one on each side of the
bottom of the assembly. Remove these
screws, then remove the bullnose weld
assembly from the griddle.
Figure C
3. Reverse the procedure to install.
Heat Shield
1. Remove control panel.
2. The heat shield clamps on the front of the
griddle and can be removed by grasping
the top of the shield and pulling forward.
Figure D
3. Reverse the procedure to install.
Back Panel
1. Remove all screws from rear of griddle
securing the back panel.
2. Remove the back panel. (See Figure D)
3. Reverse procedures to install.
Griddle
Bullnose
Griddle
Heat
Shield
Deflector
Plate
Panel
Connector
Control
Panel
Remove
Screw
Back
Panel