Filter
Top Products
— 9 —
F35628 (10-04)
PILOT
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AND
FOLLOW LOCKOUT / TAGOUT
PROCEDURES.
WARNING: SHUT OFF THE GAS BEFORE
SERVICING THE GRIDDLE.
1. Remove control panel and heat shield for
visual access of the pilot.
2. Reaching underneath the front of the
griddle remove the pilot tube fitting and
disengage the pilot tube from the pilot.
3. Reaching up through the square pilot
access cut out, remove the screw retaining
the pilot bracket to the unit and slip the
entire pilot assembly out from under the
front section of the unit.
4. Remove the pilot from the bracket.
5. Reverse procedures to install new pilot.
WARNING: ALL GAS JOINTS DISTURBED
DURING SERVICING MUST BE
CHECKED FOR LEAKS. CHECK
WITH SOAP AND WATER
SOLUTION (BUBBLES). DO
NOT USE AN OPEN FLAME.
6. Verify gas pressure as outlined under the
GAS PRESSURE ADJUSTMENT in the
Service Procedures and Adjustments section
of this manual. Check for proper operation.
Figure J
DUAL SOLENOID
WARNING: DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AND
FOLLOW LOCKOUT / TAGOUT
PROCEDURES.
WARNING: SHUT OFF THE GAS BEFORE
SERVICING THE GRIDDLE.
1. Remove the control panel.
2. Label and disconnect the two wires
connected to each solenoid.
3. Disconnect the input compression fitting
and the two output compression fittings.
4. Remove the screw securing solenoids to
solenoid bracket and remove solenoid.
Figure K
5. Reverse procedure to install the
replacement dual solenoid.
WARNING: ALL GAS JOINTS DISTURBED
DURING SERVICING MUST BE
CHECKED FOR LEAKS. CHECK
WITH SOAP AND WATER
SOLUTION (BUBBLES).
DO NOT USE AN OPEN FLAME.
6. Verify gas pressure as outlined under the
GAS PRESSURE ADJUSTMENT in
Service Procedures and Adjustments.
Check for proper operation.
Pilot
Assembly
Pilot
Bracket
Remove
Screw
Disconnect
Wires
Disconnect
Fittings
Screw