Filter
Top Products
— 17 —
4. To remove the Venturi/Burner assembly from the range, slightly lift up the rear of the assembly and
pull it back towards the splasher area while lifting the assembly off the burner valve quick disconnect.
Repeat step 4 until all the burner section assemblies are removed (Fig. 15, 16 and 17).
NOTE: Burner/Venturi assembly may be cleaned using a nylon brush to remove crusty debris. The
assembly may also be placed into a commercial dishwasher for cleaning. It is recommended that
the assembly be left standing to air dry and the pilot tubing be blown out with air before reinstalling.
Failure to allow the venturi to thoroughly dry will cause rusting and compromise the range operation.
The venturi air shutter adjustment is important to the function of the range open top burner(s). The
air shutter opening must be kept clean. The shutter is locked into place by use of a single screw.
Be careful not to disturb the air shutter while cleaning. It is also recommended that before
reinstalling, the entire outside areas of the Burner/Venturi assembly be coated with a spray on
cooking oil to eliminate rusting. These parts are cast iron and will rust if not properly seasoned.
5. Clean the entire 12 quart basin area with warm water, mild soap and a soft cloth. Stubborn soils
may be removed using a nylon scratch pad and mild detergent. Rinse and dry all areas
thoroughly (Fig. 18).
Fig. 15
Fig. 16
Fig. 17
Fig. 18