Filter
Top Products
— 5 —
ASSEMBLY
The range is shipped as a complete unit and does not require field assembly.
Bumper Bars (Convection Oven only)
Bumper bars equipped with this unit must be installed. Failure to install bars may result in motor
damage and will void the equipment warranty.
Legs
The range is supplied on 6"(152 mm) adjustable stainless steel legs. (For additional leg information
see Leveling section of this manual).
Casters
Ranges mounted on casters must use a flexible connector
(not supplied by Vulcan) that complies with the Standard for
Connectors for Movable Gas Appliances, ANSI Z21.69 •
CSA 6.16 and a quick-disconnect device that complies with
the Standard for Quick-Disconnect Devices for Use With
Gas Fuel, ANSI-Z21.41 • CSA 6.9. In addition, adequate
means must be provided to limit movement of the appliance
without depending on the connector and the quick-
disconnect device or its associated piping to limit appliance
movement. Attach the restraining device at the rear of the
range as shown in Fig. 1.
If disconnection of the restraint is necessary, turn off the gas supply before disconnection.
Reconnect this restraint prior to turning the gas supply on and returning the range to its installation
position.
Separate instructions for installing casters to the range are included with the casters.
Note: If the range is installed on casters and is moved for any reason, it is recommended that the
range be releveled front to back and side to side for even baking.
PL-51219
CONNECT GAS LINE
STRAIN
RELIEF HERE