Filter
Top Products
Fig. 10
5. Remove piping from gas valve inlet and install on
replacement valve. Ensure the factory tags that
are wired to the piping remain installed.
NOTE: Replacement gas valve contains valve plate,
orifice and o-ring already assembled. The gas valve/
blower design allows natural and propane gas kettles
to use the same orifice size. Labels for gas type are
also included.
Clean pipe threads and apply thread
sealant that is suitable for use with propane gas.
6. Reverse procedure to install.
7. Affix the appropriate gas label (natural or
propane) on top of gas valve.
8. Perform
GAS VALVE/BLOWER INLET
PRESSURE CHECK.
BLOWER
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove
GAS VALVE from blower.
2. Remove BOTTOM COVER.
3. Separate burner manifold compression fitting on
gas supply tube (feeding burner).
Fig. 11
4. Remove electrical connectors (2) from blower.
5. Remove blower from kettle at burner manifold.
Fig. 12
A. Remove blower from burner manifold (4
screws).
B. Remove swirl plate (3 screws) and blower
plate (2 screws) from blower intake.
K Series Gas Kettles 2/3 Jacketed Stationary and Tilting - REMOVAL AND REPLACEMENT OF PARTS
F45461 Rev. A (0713) Page 10 of 44