Filter
Top Products
Fig. 29
10. Lift spacer ring off gear reducer. Retain for use
on replacement gear reducer.
Fig. 30
11. Remove bolts (4) securing gear reducer and
control box to kettle frame.
NOTE: A one piece nut plate assembly may be
installed at the rear of gear reducer in place of
individual mounting nuts to ease assembly.
Fig. 31
12. Pull gear reducer away from kettle by working it
off the kettle pivot shaft until free. Retain key for
use on replacement gear reducer.
NOTE: Control box can be moved as necessary for
ease of gear reducer removal.
13. Remove reducer shaft extension from gear
reducer shaft (2 roll pins). Retain for use on
replacement gear reducer.
Fig. 32
14. Reverse procedure to install replacement gear
reducer.
15. Perform TILT SWITCH (2S) ADJUSTMENT -
POWER TILTING OPTION ONLY and DOWN
LIMIT SWITCH (3S) ADJUSTMENT - POWER
TILTING OPTION ONLY.
K Series Gas Kettles 2/3 Jacketed Stationary and Tilting - REMOVAL AND REPLACEMENT OF PARTS
Page 17 of 44 F45461 Rev. A (0713)