Filter
Top Products
ELECTRIC BRAISING PANS - REMOVAL AND REPLACEMENT OF PARTS
F35410 (May 2003) Page 6 of 32
2. Remove power supply box cover.
3.
Disconnect lead wires then remove the
component being replaced
.
4. Reverse procedure to install the replacement
component.
5. Check braising pan for proper operation.
TEMPERATURE CONTROLLER
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
1. Remove control box from the control panel as
outlined under COVERS AND PANELS.
2. Disconnect lead wires from temperature
controller.
3. Remove temperature controller from control
box.
4. Pull temperature dial from potentiometer shaft
and remove mounting nut.
5. To install:
A. Align tab on potentiometer with positioning
bracket on panel.
B. Install mounting nut and tighten.
C. Adjust stop nut on potentiometer body (as
necessary) to ensure a water tight seal on
mounting nut.
D. Attach temperature dial.
6. Reverse procedure from step 3 to complete the
installation.