Filter
Top Products
ELECTRIC BRAISING PANS - REMOVAL AND REPLACEMENT OF PARTS
F35410 (May 2003)
Page 9 of 32
7. Reverse procedure from step 5 to complete the
installation.
8. Adjust pan position/down limit switch on switch
mounting bracket as outlined under PAN
POSITION/DOWN LIMIT SWITCH
ADJUSTMENT in SERVICE PROCEDURES
AND ADJUSTMENTS.
UP LIMIT SWITCH
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
1. Remove front panel as outlined under
COVERS AND PANELS.
2. Disconnect lead wires
from switch.
3.
Remove switch from mounting bracket.
4. Reverse procedure to install and check for
proper operation.
LID SWITCH
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
1. Remove lid switch cover from lid switch
support bracket.
2. Remove switch from lid support bracket.
3. Lift terminal cover off switch body and
disconnect lead wires.
4. Reverse procedure to install and adjust switch
as outlined under LID SWITCH ADJUSTMENT
in SERVICE PROCEDURES AND
ADJUSTMENTS.
THERMOCOUPLE PROBE
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
1. Access temperature controller as outlined under
TEMPERATURE CONTROLLER .
2. Disconnect thermocouple lead wires.
3. Raise the pan to the full tilt position.
4.
Remove harness cover.