TROUBLESHOOTING SUGGESTIONS
SYMPTOM
No power to appliance
Oven will not heat
Blower fan will not run
Door pops open during
cook cycle
Section of cooktop won’t
heat or not hot enough
POSSIBLE CAUSE
Circuit breaker off or tripped
Power cord unplugged or damaged
Fuse blown or loose
Power switch turned to OFF or FAN
Temperature control not set
Oven door not closed
Hi-limit control tripped on excessive
oven temperature
Damaged controller
Fan switch OFF
Damage to internal components
Latch out of adjustment
Control not turned ON
Damage to internal component
SUGGESTED REMEDY
Reset circuit breaker
Check power cord
Plug in or repair as required
Check power fuses. If blown,
correct problem and replace
fuses
Turn power switch ON
Set to desired temperature
Be sure door is closed and
latched
Allow oven to cool
Hi-limit will reset
Contact Authorized Wells
Service Agency for repairs
Turn fan switch to HIGH or
LOW
Contact Authorized Wells
Service Agency for repairs
Adjust latch
Set control
Contact Authorized Wells
Service Agency for repairs
NOTE: There are no user
serviceable components in the
appliance. In all cases of
damage or component
malfunction, contact your
Authorized Wells Service
Agency for repairs.
CAUTION: ELECTRICAL SHOCK HAZARD
Removal of any cabinet panel will result in exposed electrical circuits.
Any procedure requiring the removal of any cabinet panel must be performed
by a qualified technician only.
CAUTION: ELECTRICAL SHOCK HAZARD
Fuse replacement may expose dangerous voltages.
Fuse replacement must be performed by a qualified technician.
13
M273 p/n 303875 OpManual OC-1 & OC-4 Convection Ovens