Filter
Top Products
Ice and cold water dispenser...
FOR ICE:
Press a
sturdy
glass against
the ice dispenser bar. (Pres-
sure and tumbling ice can
break a fragile glass.]
The
first few batches of ice
from the ice maker may have
a bad taste from new plumb-
ing and parts. Throw them
away.
PRESS AGAINST
ICE DISPENSER BAR
The small tray beneath the dispenser is deslgned to evaporate
small
spills. There is not drain in this tray. Do not pour water into it.
Chilled
water comes from a tank behind the
meat drawer. It holds about 50 ounces (1.5L).
When the refrigerator is first hooked up press the
water dispenser with a glass or jar until you have
drawn and discarded 2 or 3 quarts (1.9 to 2.8L).
The water you draw and discard will rinse the
tank and pipes.
Allow several hours to chill the first tankful.
Ice is dispensed from the ice maker storage bin
in the freezer. When the dispenser bar is pressed, a
trapdoor opens in a chute between the dispenser
and the ice bin. Ice is moved from the bin and falls
through the chute. When the trapdoor closes, a
faint buzzing sound may be heard for a few
seconds.
Common Problems
PROBLEM
Dispenser won’t
work.
Ice dispenser
won’t work.
Ice dispenser
stops working.
Off-taste or odor
in ice.
FOR CHILLED WATER:
Press a
sturdy
glass against
the water dispenser bar.
(Pressure can break a fragile
glass.] Remove the glass to
stop dispensing.
Dispense enough water
every
week to maintain a
fresh supply.
CAUSE
Freezer door open
Ice bin not properly installed
Wrong ice in bin.
Ice dispenser control set on MI~w
MED or MAX.
Ice dispenser bar held In too Ic g
The MIN/MED/MAX and CONT Pads control the
amount of ice dispensed at one time. Select the
setting that meets your family’s needs.
The CONT setting will dispense ice as long as the
Ice dispenser bar is held.
NOTE: Large amounts of ice should be taken
from the bin, not through the dispenser. The MAX
FRZ/ICE setting can be used for maximum ice
production.
To set the ice control:
1. Press the Ice Selection Pad forthe amount of ice
you want. The signal light on the pad will come
on briefly
2. This amount of ice will be dispensed each time
the ice diSDenSer bar is Dressed. Press another
Ice Select& Pad to cha’nge the setting
Ice attracts airborne odors.
Old ice.
Water quality
Foods not properly wrapped.
Ice bin and freezer may need
cleaning.
Plumbing to ice maker
New ice maker
SOLUTION
l
Close the freezer door.
l
Make sure bin IS pushed all the way in
l
Use only ice crescents from ice
maker. Other shapes won’t dispense
properly.
* Select CONT setting
l
Wait about 3 minutes for the dispenser
motor to reset.
. Large amounts of Ice should be taken
from the bin.
not through the dispenser.
* Use rapidly or store in covered
container
l
Dump old ice and make new supply.
l
Water containing minerals (such as
sulfur] may require a filter to remove.
l
Wrap properly. See pages 15 and 16.
0 Clean freezer and ice bin. See
Cleaning Chart on page 13.
l
Follow installation instructions for proper
ice maker water supply hook-up.
= The first few loads of ice from a new ice
maker may have an off-taste. Dump
ice and make new supply.