Filter
Top Products
Install properly.. .
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape
and any inside labels before using the re-
frigerator. To remove any remaining glue:
1.
Rub briskly with thumb to make a ball then
remove.
OR
2. Soak area with liquid hand dishwashing
detergent before removing glue as described
in step I.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
1. Allow Yz inch (1.25 cm) space on each side and
at the top of the refrigerator for ease of
installation.
2. If the refrigerator is to be against a wall, you
might want to leave extra space so the door
can be opened wider.
3. The refrigerator back can be flush against the
wall.
Level refrigerator-freezer.. .
TO ADJUST
FRONT ROLLER
I I
VELLING SCREW
IGHT TO RAISE;
LEFT TO LOWER
1. Remove base grille (see page 9).
2. To raise front, turn screw in direction shown.
3. To lower front, turn screw in the direction shown.
4. Check with level.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTIONS LABELS INSIDE YOUR REFRIGER-
ATOR.
Do not remove the Tech sheet fastened under
the refrigerator at the front.
Clean it...
Clean your refrigerator before using it. See
cleaning instructions on page 13.
Plug it in...
3-PRONG GROUNDING
TYPE WALL RECEPTACLE
REFRIGERATOR
3-PRONG
POWER CORD
GROUNDING PLUG
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See individual electrical requirements
and grounding instructions sheet in your literature
package.
The ON/OFF switch (inside the freezer door just
above the ice dispensing slot) should be set to ON
before you plug the refrigerator in for the first time.
The refrigerator temperature is preset to 36°F (2”C),
the freezer to 0°F ( - 18°C).
Turn off beeping...
The warm refrigerator and freezer temperature
warnings will beep eight times every two minutes
when the refrigerator is first plugged in. To turn
beeping off until refrigerator and freezer reach
normal temperatures press and hold the RESET Pad
until two beeps are heard [see Display Mode,
page 51.