Filter
Top Products
Electronic control center TEMPERATURE
TEMPERATURE
-SIGNAL LIGHTS / DISPLAY
SIGNAL
LIGHT
POWER
SAVER PAD
AUTO
I
TEMP PAD------i
FRMCE PAD
DISPLAY WARNING
SIGNAL LIGHTS
TEMPERATURE
ADJUSTING PADS
NIGHT
/
ICE “/
‘FRZ TEMP ‘REF TEMP ‘SET
LIGHT PAD’
SELECTION PADS PAD
PAD TEMP PAD
A beep will be heard each time a control pad is pressed. The signal light on a control pad will come on
when that control is first pressed.
Display mode...
The display mode is used to demonstrate the
Electronic Control Center. Using the display mode
will also turn off the beeping from the warning
signals. The refrigerator will continue to operate
normally while the Electronic Control Center is in
the display mode.
To start the display mode, press and hold the
RESET Pad until two beeps are heard. While in the
display mode, the five signal lights will flash. Press-
ing the control pads during the display mode will
not change any settings. However, if a control pad
is pressed, you will hear a beep and the signal
light will come on.
Power saving pad...
The POWER SAVER Pad on the Electronic Control
Center operates low wattage electric heaters
around the door openings. These heaters keep
moisture from forming on the outside of the re-
frigerator when the humidity is high.
Setting the temperatures...
When the refrigerator is first plugged in, the
freezer temperature is preset to 0°F ( -18°C) and
the refrigerator is preset to 36°F (2°C).
Give the refrigerator time to cool down com-
pletely before adding food. (This may take sev-
eral hours).
These settings should be about right for nor-
mal household refrigerator usage.
The temperatures will be set about right when
milk or juice is as cold as you like and ice cream
is firm.
To cancel the display mode press the RESET Pad
once. The display mode will automatically cancel
after being on for 8 hours.
NOTE: If the display mode is entered while the
ON/OFF switch is OFF, “CO” will show on the dis-
play. You must set the ON/OFF switch to the ON
position before the refrigerator will start cooling.
1
When humidity is low, press the
POWER SAVER Pad to turn the Power
Saver signal light on. This will turn off
the heaters.
2. If moisture forms on the outside of
the refrigerator, press the POWER
SAVER Pad to turn the Power Saver
signal light off. This will turn the heat-
ers on.
If you need to adjust temperatures in the re-
frigerator or freezer do the following:
l
Adjust the refrigerator or freezer temperature.
l
Wait at least 24 hours,
l
If needed, make further temperature adjust-
ments to the refrigerator or freezer.
continued on next page
5