Filter
Top Products
Removing the crisper, meat drawer
and covers.. .
PUSH THE TAB TO
To remove the crisper and meat drawer:
1.
Slide crisper and meat drawer straight out to
stop.
CLEAR THE MEAT
DRAWER COVER.
2. Lift the front.
3. Slide the rest of the way out.
4. Replace in reverse order.
To remove the covers:
l
Covers are held in place by two pegs at the
back and two notched tabs in front.
1. Press front tabs out of the way.
2. Liff cover front.
3. Lift back off the pegs.
4. Replace in reverse order.
Changing the light bulbs...
PULL OUT AT THE BOTTOM.
Removing the base grille...
To remove the grille:
Light bulbs behind top refrigerator and freezer
light shields:
1. Pull bottom of light shield straight out.
2. Lift top of shield off supports,
3. Replace with a 40-watt appliance bulb.
4. Replace panel in reverse order.
Light bulb behind ice maker:
1. Remove the ice bin (see ice maker instructions
page 11.
2. Replace bulb with a 40-waftappliance bulb.
3. Replace ice bin.
Dispenser light:
1. Reach the bulb through the dispenser area.
2. Pull down on bulb. Do not twist.
3. Replace with a 12 volt bulb (Part No. GE 904). This
bulb is available in the automotive department
of most stores.
METAL CLIPS
-I
SUPPORT TABS
1. Open the doors.
2. Pull grille outwards as shown.
3.
Do
not remove Tech sheet fastened behind
grille.
To replace the grille:
1. Line up grille support tabs with metal clips.
2. Push firmly to snap into place.
3. Close the doors.
9