Filter
Top Products
Install properly...
Remove sales labels...
Check the strength of the floor It should hold the
weight of a fully loaded freezer
Pick a safe place, indoors, away from in-
flammables such as gasoline.
Allow 3 Inches (7 5 cm] air space on top of freezer
for proper ventilation
Allow at least on inch (2 5 cm] between the
freezer condenser, on the bock of the unit, and
the wall
Allow ‘1. Inch (1 25 cm) on each side of the freezer
for ease of lnstallat~on
If the freezer
IS
to be in o corner, you might wont to
leave extra space on the hinge side so the door
con be opened wider.
. -Pi.i
Level freezer.. .
so the door will stay open at any position
I I
This freezer has 2 threaded leveling legs that ore
shipped in a separate package.
1. Screw these legs all the way into bolt holes in the
bottom front corners of the freezer
2. Slide the freezer into place.
3. Adjust front legs to level the freezer
-To raise front, turn legs counterclockwise.
-To lower front, turn legs clockwise.
4. Check with level
5. After freezer is fully loaded. recheck with level.
Remove the Consumer Buy Guide label and any
inside labels before using the freezer.
To remove any remalning glue:
1 Rub briskly with thumb to make a ball. then
remove
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent In 1 quart worm water) be-
fore removing glue OS described in step 1
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
surface finish.
NOTE: DO NOT REMOVE the Tech Sheet fas-
tened under the freezer at the front.
, I _i ., . ,
Clean it . . .
Clean your freezer before ”
usinq It See cleanlna
instr;ctions on page-7
grounding plug
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is required.
It is recommended that a separate circuit serving only
this appliance be provided. Use a receptacle
which cannot be turned oft with a switch or pull
chain. Do not use an extension cord.
Attach retaining clip over power cord plug from
literature package inside the freezer.
4