Filter
Top Products
Using your freezer
Setting the temperature control...
Adjusting the temperature control...
To
sethI
or n
cone
start, turn control to the mrddle of the dual Thus
?g IS desrgned to marntarn the temperalure at
ear 0 F( 17 8 “C] under normal operating
drtrons
1 Turn control to hrgher number for colder temper-
atures
2 Turn to lower number for less cold temperatures
Cooling freezer first...
1 Allow freezer to cool 6 to 8 hours before filling with
frozen food.
2 Let it cool overnrght before adding large amount
of unfrozen food.
Note: When freezer IS first started, the compressor
WIII run constantly until the cabinet IS cooled It may
take up to 6 to 8 hours or longer, depending on room
temperature and the number of times the freezer
door IS opened
After the cabinet IS cooled, the compressor will
turn ON and OFF as needed to keep the freezer at
the proper temperature
The Power Saving Control...
operates electric heaters These heaters help pre-
vent moisture from forming on the outside of the
freezer when humidity is high.
1 Use the OFF setting to save energy when humidity IS
low.
2. Use the ON setting only if moisture forms on the out-
side of the freezer.
*. ,,;,r,<..r >. ‘f.L(I j
IV. vi /> I .? 1.1,
Removing and adjusting the top ’
freezer shelf...
To remove shelf:
1. L~fl front, then back off supports.
2 Replace in reverse order.
To adjust shelf:
1 Remove shelf
2 Remove supports by sliding upwards
3 Replace supports on desired level
4 Replace shelf.
Adjusting the freezer shelves...
To remove shelf:
1 Remove food from shelf
2 Slide shelf straight out to stop
3 Lift front
Guide Stop .
4 Slide the rest of the way out
Shelf Stop
To replace shelf:
1 Fit back of shelf on top of gurdes with wire stops on
bottom of guides
2 Loft front, then slide shelf until It clears the guide
stops
,. .,, : *,” . ,~.