Filter
Top Products
Changing the light bulb...
WARNING: To avoid possible shocks, first unplug
I
1.
2
3.
4
freezer or turn off electricity leading
to freezer at the main power supply.
Removing the bottom basket...
To remove:
1 Lift front of basket out of supports
2 Pull out.
Lift the Front,
Then Pull Out.
To replace:
1 Positron back of basket on the rear wall supports
2. Lower front into place
The key eject lock...
can help reduce the hazard of chrld
entrapment
._..,
,I
The signal light...
automatically warns of any unexpected
Signal Light
/
If the srgnal light IS not glowing, immediately check
l
for power Interruptron,
l
for an unplugged power cord,
l
for a burned out signal light.
Remove the light shield from the side of the control
panel Depress the back of the shield to release the
tabs, then pull away
Replace bulb with a 40-watt appliance bulb.
Replace the light shreld. Insert the shield tabs in the
slots, then press the shield to snap into place
Plug In power cord or switch on electricity
To lock or unlock the freezer you must hold the
key In the lock whrle turning The lock IS spring
loaded so the key cannot be left In the lock
If the key IS lost, contact your WHIRLPOOL
dealer for a replacement Always give the com-
plete model and serial number of your freezer
when requesting a replacement key.
To replace burned out signal light:
1 Unplug power cord from outlet.
2. Open the freezer door.
3. Unplug burned out light and replace with one of
same wattage and size. Signal light can be
ordered from your WHIRLPOOL dealer,
Part No. 1103680
4. Close freezer door and plug power cord Into outlet.
6