Whirlpool GC1SHAXM Refrigerator User Manual


 
4-11
REMOVING THE COMPRESSOR TERMINAL BOX,
THE RELAY & OVERLOAD AND RUN CAPACITOR
1. Unplug refrigerator or disconnect power.
2. Remove the six screws from the unit com-
partment cover and remove the cover.
b) Use a screwdriver and unsnap the
locking tab at the lower front of the
compressor, then pull the box away
from the compressor so that you can
access the relay and overload.
4. To remove the compressor terminal
box:
a) Use a screwdriver and pry the top of the
terminal box away from the compres
-
sor.
Continued on the next page.
3. Place a screwdriver blade into the indi-
cated slot of the compressor terminal box
cover, and pry the cover off the box.
Unit Compartment Cover Screws (3 of 6)
Pry Cover Off
Terminal Box
Pry Lower Front Of
Terminal Box Away
From The Compressor
Pry Top Of Terminal Box
Away From Compressor
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING