Filter
Top Products
4-12
6. To remove the run capacitor:
a) Remove the terminal box from the
compressor (see step 4 for the proce
-
dure).
b) Use a 1/2
˝ socket and remove the run
capacitor nut from the bracket.
5. To remove the relay and overload:
a) Remove the terminal box from the
compressor (see step 4 for the proce
-
dure).
b) Pry the relay off the top two pins of the
compressor.
c) Pry the overload off the bottom pin of
the compressor.
d) Disconnect the white (1), blue (2), and
black (3) wires from the relay terminals.
NOTE: The terminal numbers are em-
bossed on the connector.
e) Disconnect the black wire from the
overload terminal.
Overload
c) Disconnect the white (1) and black (3)
wires from the relay terminals (see the
photo at the bottom left).
d) Loosen the screw from the left strain
relief and remove the wire and run
capacitor.
Relay
Overload
Relay
Black (3)
White (1)
Blue (2)
Black
Strain Relief
Run Capacitor
Wire
1/2ʺ Socket
Run Capacitor