Filter
Top Products
9
Fig. 2-15
Fig. 2-16
Dishwasher Dispenser
Disassembly
1. Remove the drawbar spring.
(Fig. 2-15)
2. Grasp the lower edge of the drawbar
and pull it away from the panel stop.
Slide the drawbar down until the draw
bar holes align with the locking tabs,
then remove the drawbar. Note how the
locating tabs behind the drawbar align
with their respec-tive locating holes in
the drawbar.
(Fig. 2-16)
3. Turn the wet agent cap and seal assem-
bly counterclockwise and remove it.
(Fig. 2-17)
4. Remove the seal from the cap.
5. Use Special Tool - Part No. 303918 or a
¾” socket to press over the attaching
tabs in the wet agent cap opening.
Remove wet agent dispenser assembly.
(Fig. 2-17)
6. Remove wet agent dispenser actuator
by spreading the two (2) locking tabs.
(Fig. 2-18)
7. Remove the actuator slide from the wet
agent dispenser actuator.
8. Remove the diaphragm spring and
diaphragm.
9. Use a screwdriver to gently release the
lower tab and remove the detergent
door actuator assembly. As you do,
note the position of the door latch level
through the hole in the lower slide.
(Fig. 2-19)
10. Remove the detergent door latch by
carefully spreading the latch snap
locking tabs apart with a screwdriver
while pushing firmly against the end of
the door latch lever until the lever is
released through the hole.
11. Remove the upper slide, the slide
spring and the lower slide.
(Fig. 2-20)