Filter
Top Products
41
Maintenance and cleaning
Before any cleaning or
maintenance operation,
unplug the appliance from
the mains or disconnect the
electrical power supply.
Periodically clean the
refrigerator and freezer
compartments with a sponge
dampened in a solution of
lukewarm water and vinegar.
Rinse and dry. Never use
detergents or abrasives.
Never clean refrigerator parts
with flammable fluids. The
fumes can create a fire
hazard or explosion.
Clean the outside with a
sponge dampened in
lukewarm water.
Dry with a soft cloth.
Do not use steam cleaners.
Clean the condenser and
seal.
Note: The refrigeration
system pipes are located near
the defrost pan and can
become hot. Periodically
clean them with a vacuum
cleaner.
Always disconnect the
refrigerator from the
power supply before
replacing any light bulbs.
Removal of the
refrigerator light
cover:
Loosen the screw that
secures the light cover.
Pull downwards and slide
the cover towards the rear
of the refrigerator.
Replace the bulb with one
of the same type available
only from our After-sales
Service Centre.
Put the light cover back
into place, repeat the
above steps in reverse
order.
How to replace the
freezer upper
compartment bulb:
Remove the light shield by
pressing the side sections;
Remove the bulb and
replace it with one of the
same type available only
from our After-sales Service
Centres or authorized
dealers;
Put the light shield back
into place, repeat the
above steps in reverse
order.
How to replace the
lower bulb in the
refrigerator and
freezer
compartments (on
some models):
Remove the light shield by
grasping its upper central
part;
Pull the front and, at the
same time, slightly turn the
shield to one side;
Remove the bulb and
replace it with one of the
same type available only
from our After-sales Service
Centres or authorized
dealers.
To replace the light shield:
Grasp the upper central
part of the light shield;
Insert the tabs of one side
of the shield into the
grooves;
Gently bend the light shield
in the centre to insert the
tabs on the other side.
How to replace the
dispenser bulb (on
some models):
Grasp the bulb in the
dispenser recess;
Remove the bulb and
replace it with one of the
same type available only
from our After-sales Service
Centres or authorized
dealers.
4gb33015.fm Page 41 Wednesday, March 10, 2004 4:02 PM