Filter
Top Products
29
Guide to the refrigerator/freezer and ice/water dispenser control panel
Standby
When button is
pressed, the appliance
switches to standby. This
function deactivates both
the refrigerator and
freezer compartments.
When the standby function is
activated, two green dots will
appear on both of the displays.
To restore the previous setting,
carry out the same procedure
until the previous temperatures
appear on both of the displays.
When the appliance is on
standby the light inside the
refrigerator compartment is off.
Remember that this operation
does not disconnect the
appliance from the power
supply.
Fast freezing
This function must be
activated before freezing
fresh food. To activate the
function press the specific
button (yellow LED lights
up). The function switches
off automatically after 24
hours or manually by
pressing the button again.
Freezer compartment
display
Shows the freezer compartment
temperature setting.
T° selection limit:
from - 18°C, least cold
temperature, to - 24°C coldest
temperature.
The set T° is stored and will
automatically be restored even
after a power failure or if the
appliance is switched off by
pressing the standby button.
Freezer
compartment
temperature
selection and
control
To change the internal
temperature press buttons
until the desired value is
reached and shown on the
display.
Refrigerator
compartment display
Shows the refrigerator
compartment temperature
setting. T° selection limit: from +
2°C coldest temperature to + 6°C,
warmest temperature.
The set T° is stored and will
automatically be restored even
after a power failure or if the
appliance is switched off by
pressing the standby button.
Refrigerator
compartment
temperature
selection and
control
To change the internal
temperature press buttons
until the desired value is
reached and shown on the
display.
Fast cooling
Switches on the Fast Cooling
function and shows its
operating status. Use this
function to chill the fresh
food stored in the refrigerator
compartment rapidly. The
function switches on when the
button (yellow LED) lights up
and switches off automatically
after 6 hours or manually by
pressing the button again.
4gb33015.fm Page 29 Wednesday, March 10, 2004 4:02 PM