Filter
Top Products
4-13
10. 18˝ Models Only: Remove the six screws
from the counterbalance plate and remove
the plate from the rear of the unit.
11. From the rear of the unit, remove the six
hex-head screws from the channel cover
and remove the cover.
12. Remove the four screws from the unit com-
partment cover and remove the cover.
Unit Compartment Cover
(4 Screws)
Channel Cover
(6 Screws)
13. Cut the tie wrap from around the tubing
and wire harness inside the channel.
Tie Wrap
14. Remove the two screws from the reservoir
water trough and remove the trough.
Screw
Screw
Water Trough
Counterbalance Plate
18˝ Models
Screw (1 of 6)
Continued on the next page.