Whirlpool KUIA18NNJ*11 Ice Maker User Manual


 
4-23
REMOVING THE ICE MAKER DOOR & GASKET
(18˝ MODELS)
Hinge Screws
(2 each side)
Top Grille
Screws (1 of 2)
The 18˝ Ice Maker has a spring-loaded, drop-
down door. Since the door design is somewhat
unique, accessing procedures are included
below. To replace the gasket perform step six
only.
1. Remove the two top and two bottom screws
from the grille and remove it from the front
of the ice maker.
3. Open the ice maker door and remove the
four front hinge screws (2 per hinge) and
remove the door. NOTE: Support the door
while you remove the screws to avoid it
from falling off the unit.
2. Remove the end of the spring from the door
bracket and the screw (on some models)
from the bottom of the door hinge.
Bottom Grille
Screws (1 of 2)
Hinge Bottom Hinge
Spring Screw
Bracket
Continued on the next page.