Filter
Top Products
Number Pads
Fan and light Pads
Once you’ve touched Command Pad to tell
the oven what you want it to do, you’ll touch
Number Pads to tell it...
-a time.
- a Cook Power.
The six pads at the bottom of the control
panel control the 2-Speed Exhaust Fan and
the Cooktop Light.
Touch Fan Pad for the desired fan speed.
(NOTE: If the temperature gets too hot around
the mlcrowave oven, the exhaust fan In the
vent hood will automatlcally turn on the LOW
settlng to protect the oven. It may stay on up
to an hour to cool the oven. When thls occurs,
the Fan Pad will not turn the fan off.)
Touch Light Pad for the desired cooktop or
countertop lighting.
Audible Signals
Audible signals are available to guide you when setting and using your oven. (A programming tone
will sound each tlme you touch a pad. Two beeps will sound between cycles. A reminder tone will sound
every 60 seconds after cooking is done to remind you that something has been left in the oven. Four
beeps signal the end of the Timer function and a Cook or Defrost cycle.] If you don’t hear a tone, it is
because of incorrectly entered Instructions or because the tones have been removed. For example, a
tone will not sound if you touch a Number Pad before you touch a Command Pad.
To remove the programming tone and
remlnder tone:
l
Open the door.
l
Touch CANCEL
twice,
then touch START.
l
Programming and reminder tones will
be cancelled.
To replace the tones:
l
Repeat the steps above.
To remove all tones:
l
Open the door.
l
Touch CANCEL
twice,
touch 0, then touch START.
l
All audible tones (including Timer signal] will be
cancelled.
NOTE: Do not remove all tones If you use the
tlmer.
To replace the tones:
l
Repeat the steps above.
NOTE: If your electrlclty goes off, the tones will be replaced when the electrlclty comes back on.
Setting the Clock
When the oven is first plugged in, a tone sounds and the Display shows “88:881’ If the
electric power ever goes off, the Display will again show all 8’s when the power comes
back on.
You can cook or use the Timer without setting the Clock, but the Display will be
blank after cooking.
DO THIS...
THIS HAPPENS...
.
Him
I. Touch CLOCK SET.
p
l
__
The Display will show a “0” and the
I
colon will start to flash.
The first
Number Pad must be touched withln
5 seconds or the Display will go
blank.
If this happens, touch CLOCK
SET again and continue.
6