Filter
Top Products
Using Your Microwave Oven
Continued
.
Ma
Audible signals
Audible signals are available to guide you when
setting and using your oven. A programming tone
will sound each time you touch a pad. Two beeps
will sound between cycles. A reminder tone will
sound every 30 seconds after cooking is done to
remind you that something has been left in the
oven. Four beeps signal the end of the Minute
Timer function. If you don’t hear a tone, it is
because of incorrectly entered instructions or
because the tones have been removed. For
example, a tone will not sound if you touch a
Number Pad before you touch a Command Pad.
To remove the programming tone:
1. Open the door.
2. Touch CANCEL twice, then touch START.
3. Programming and reminder tones will be
cancelled.
To replace the tones:
l
Repeat the steps above
To remove all tones:
1. Open the door.
2. Touch CANCEL twice, touch 0, then touch
START.
3. All audible tones (including Minute Timer signal)
will be cancelled.
NOTE: Do not remove all tones if you use the
Minute Timer.
To replace the tones:
l
Repeat the steps above
NOTE: If your electricity goes off, the audible
signals will come back on. Repeat steps above if
you want to remove them again.
Setting the clock
When the oven is first plugged in, a tone sounds
and the Display shows 88:88. If the electric power
ever goes off, the Display will again show all 8’s
when the power comes back on.
You can cook without setting the clock, but the
Display will be blank after cooking.
1. Touch CLOCK SET. The Display will show a “0”
and the colon will start to flash. The first
Number Pad must be touched within 5
seconds or the Display will go blank. If the
Display goes blank, touch CLOCK SET again
and continue.
10