Filter
Top Products
When the cooking time ends, “End”
will show on the Display and 4 beeps
will sound. (You can stop the beeping
by opening the door or by touching
CANCEL.] “End” will remain on the Dis-
play until door is opened or CANCEL
is touched. The Display will then show
the time of day.
NOTE: If the oven light and tan come
on when you touch START, the Start
Time has not been set correctly.
Open and close door, reprogram
AUTO START time, then touch START.
Additional intormation
l
Additional cycles can be set when using AUTO START. Follow instructions
under the proper heading (Defrosting, Cooking in More Than One Cycle,
Cooking with the Temperature Probe, Using PAUSE, Using KEEP WARM) either
before or after you touch START.
l
You can change times, or add cycles at any time during the AUTO START cycle.
1. Touch the COOK Cycle you wish to change or add.
2. Touch numbers for new time.
3. Touch COOK POWER, if desired.
4. Touch number for new Cook Power, or touch COOK POWER again if high is
desired.
5. Touch START.
l
Opening the door does not stop Auto Start operation.
CAUTION:
b Use foods that will not go bad or spoil while waiting fqr cooking to start.
l
Avoid using dishes with milk or eggs, cream soups, cooked meats, poultry
or fish, or any item with baking powder or yeast.
l
Smoked or frozen meats may be used; so can vegetables, fruits and
casserole type foods.
l
Any food that has to wait for cooking to star-l should be very cold or frozen
before it is put in the oven. MOST UNFROZEN FOODS SHOULD NEVER STAND
MORE THAN TWO HOURS BEFORE COOKING STARTS.
,
Other operating hints
1.
To double check settings
while the oven is running, touch the Command Pad
for the setting you want to check. The instruction programmed for that pad will
show on the Display for 5 seconds. Then the Display returns to showing what
the oven is doing.
2. To stop the oven while it is running:
l
Open the door. The oven will stop. Restart the oven by closing the door and
touching START
l
Touch CANCEL. All instructions will be erased. You must touch in new
instructions.