Filter
Top Products
Programming tone
Each time you touch a pad you will hear a tone. If you do not hear a tone,
it is because the instruction is not correct, or it is because the tones have been
removed
EXAMPLE:
If you touch a Number Pad before You touch a Command Pad, You
will not hear a tone. The instruction is not correct.
If you want to remove the tone:
If you want to replace the tone:
l
Open the door.
. Open the door.
l
Touch CANCEL
twice,
then START.
l
Touch CANCEL
twice,
then START.
l
The tone will not sound for any
l
The tone will sound for any correct
touch.
touch.
Setting the clock
When the oven is first plugged in, the Clock/Display shows 88:88. If the electric
power ever goes off, the ClockDisplay will again show all 8’s when the power
comes back on.
You can cook or use the Minute Timer without setting the clock, but the display
will be blank after cooking.
DO THIS...
THIS HAPPENS...
The Display will show a “0” and
the colon will start to flash.
the
first Number Pad must be touched
wlthln 5 seconds or the Display will
go blank.
Touch CLOCK SET again
and continue.
2. Touch Number Pads for the
correct time of day.
The Display will show what numbers
you touched
in the order you
touched them.
This example shows
3:25.
3.
Touch START.
The colon will stop flashing. The Clock
is set.
If you have touched in an incorrect
time, such as12.65. “Err” will show on
the Display. Touch CLOCK SET and
start over.