Filter
Top Products
If the steps for usrng Ihe Automatic
MEALTIMER Clock are not followed in
order, the electric oven door lock moy be
turned on The door will then erther
l
not open;
* not close all the way (the oven light stays
on1
If the Door Won’t Open:
1.
Make sure the Clock and Start and
Stop limes are set to the right trme of
day
2. Turn the Oven Selector to CLEAN
3. Push in ond turn the Stop fime Knob
past
the right time of day.
4. Walt 30 seconds.
5. Turn the Oven Selector to OFF; the door
wilt be unlocked within 10 seconds.
If the Door Won’t Close:
1.
Make sure the Clock and Start and
Stop
i7mes are set to the rrght time ot
day. open the oven door
2. Turn the Oven Selector to CLEAN
3. Push in and turn the Stop Time Knob
past
the right time of day
4. Push the automatic oven light switch I”
and hold it in for 10 seconds
5. Let the oven lighl switch go and turn the
Oven Selector to OFF
6. Push I” the automatic oven light switch
and hold II for another10 seconds
7.
Close the oven door
THE OVEN LIGHTS
Both oven lights will come on when you push the
Light
Switch. Push the
switch again to shut them OH Both lights will also come on when an oven door IS
opened.
To replace the upper oven light bulb:
- I,
1.
Turn oh’the electric power
at the main power supply
2. Remove the bulb cover by
3. Remove the Ilght bulb tram
pulling oul on the wire its socket
holder and moving It to Ihe
side
4. Replace the bulb with o
5. Replace the bulb cover
40.wall
appliance
bulb and snop the wire holder
available from most grc-
in
place
The bulb must
cery, variety and
have this cover when the
hardware stores.
oven Is being used.
6. Turn electrical power back
on at morn power supply.
To replace the lower oven light bulb:
1. Turn off the electric power 2. Remove the llghl bulb
at the main power supply
, from Its socket
3. Replace the bulb with o
IO-watt appliance
bulb
available from most gro-
cery, variety and
hardware stores Turn the
power back on al the
main power supply
THE OVEN VENTS
When the oven is on. hot air and molsfure
escape through a vent on top ot Ihe control panel
These vents are needed for olr clrculatlon
Do not block the vents.
Poor baktng can resull