Whirlpool RBS277PD Convection Oven User Manual


 
25
3. Set temperature (optional).
Do this step if you want to set a tem-
perature other than 350°F. Press s to
raise the temperature or t to lower the
temperature in 5°F amounts. Use these
pads until the desired temperature
shows on the small display. (If the Temp
pads are held down the temperature will
change faster.)
4. Press Cook Time pad.
5. Set cook time
Press the “up” () or “down” () pad(s)
until the correct time shows on the
display.
6. Start oven.
NOTES:
You can change the temperature or
time settings any time after pressing
the Start/Enter pad by repeating Steps
2 through 5.
The display will show “door” and the
heating elements will not heat if the
door is open when you try to bake/roast.
When you press the Start/Enter pad,
the display will count down the baking/
roasting time in hours and minutes (if
cook time is more than 1 hour) or in
minutes and seconds (if cook time is
less than 1 hour).
7. When cooking is done:
The oven will turn off automatically and
beep four times. You will also hear four
1-second tones every minute (unless
they have been disabled [page 11]) until
you press the Off/Cancel pad.
PRESS YOU SEE
(example shows Bake at 375°F
[or 191°C])
PRESS YOU SEE
F
BAKE
TIMECOOK
COOK
TIME
TEMP
PRESS YOU SEE
HR MIN
F
BAKE
TIMECOOK
(example shows 30-minute
baking/roasting time)
PRESS YOU SEE
START
ENTER
5 SEC
O
N
F
BAKE
HEAT
DTIME TIMECOOK
(display counts down cook time)
YOU SEE
TIMECOOK
F
BAKE
continued on next page
USING YOUR OVEN