Filter
Top Products
4. Lift
out
the reflector bowl. See “Cleaning
chart” on page 26 for cleaning
instructions.
Replacing
1.
Make sure
all control knobs are turned
off and cool before replacing surface units
and reflector bowls.
2. Line up
openings in the reflector bowl
with the surface unit receptacle.
3.
Hold
the surface unit as level as possible
with the terminal just started into the
receptacle.
4. While pushing
the surface unit terminal
into the receptacle,
lift
a little on the edge
of the unit nearest the receptacle. When
the terminal is pushed into the receptacle
as far as it will go, the surface unit will fit
into the reflector bowl.
_--
iill
-z
i-
00
0a
18