Filter
Top Products
Removing surface units and reflector bowls:
1. First, be sure the Surface Unit Controls are all “OFF” and
that the
surface units are cool.
2. Lift each surface unit about an inch (2.5 cm) at the edge away from the
plug-in (receptacle). Pull the unit straight away from the plug-in. Do
not luash
surjace
units: they will burn themselves clean during normal
use.
3. Lift out the reflector bowls.
Hold surface unit level
when replacing.
Prop up the top with
support rod.
Replacing reflector bowls and surface units:
1. Be sure the surface unit controls are on “OFF.”
2. Put the reflector bowls back into their places. Make sure you can see
the plug-ins (receptacles) for the surface units through the square
hole in the side of each bowl.
3. Hold the surface unit level with the prongs (terminals) pointing at
the plug-in.
4. With the prongs started in the plug-in, start pushing in on the surface
unit. At the same time, lift a little on the side of the surface unit that’s
by the plug-in.
5. Make sure the surface-ulllt prongs are pushed into the plug-lrl as far
as they will go The surface unit should fit into the reflector bowl
and be level.
Cleaning under the cooktop:
Pull to stop. Lift; pull
again.
To clean the area under the cooktop, lift the front of the cooktop at
the center. Raise the swing-up rod to hold it. (Be sure the tip of the rod is
in the notch in the cooktop ) Use warm soapy water and a sponge or cloth.
Scouring powders or any other abrasive cleaner can scratch the chrome
cooktop.
Be careful not to raise the cooktop so high that it touches the
control console. And don’t drop it. Dropping the cooktop can damage side
panels and surface units.
Removing the storage drawer (use care when handling the drawer):
The drawer below your oven is meant to store pots and pans.
Never keep anything in there that will burn or melt.
You may want to remove the drawer for cleaning under the range
Pull it straight out until it stops. Use care when handling the drawer. Lift
the front and pull some more to get it over the stop. Now slide it out until
it stops again Lift the drawer away from the range until it slips out of the
guides.
To put it back, fit the side rails at the back of the drawer into both
guides on the range. Push it closed while lifting the front to get past the
stops.