Filter
Top Products
11
HR MIN
TIMER
SET
TIMER
OFF
BAKEBAKE
CUSTOM
TEMP
START
ENTER
OFF
CANCEL
CLOCK LIGHTLIGHT
AUTO
CLEAN
HEAT BAKE BROIL LOCK'D TIMER
O
N
BROIL
5 SEC
THE ELECTRONIC OVEN CONTROL
Start/enter
pad
(p. 13)
Hour
pads
(p. 12)
Minute
pads
(p. 12)
Off/
cancel
pad
(p. 13)
Display/clock
•
When you first plug in the range, everything on
the display will light up for 1 to 2 seconds, then
a time of day and “PF” will appear on the temp-
erature display. Press the off/cancel pad to clear
“PF” from the display. If, after you set the clock
(see “Setting the clock” later in this section), “PF”
again appears on the display, your electricity was
off for a while. Reset the clock, if needed.
•
When you are not using the oven, the control is
an accurate clock.
•
When you are using the oven or minute timer,
the display will show times, temperature settings,
and what command pads have been pressed.
•
When showing the time of day, the display will
show the hour and minutes.
•
When you are using the minute timer, the display
will show minutes and seconds in the following
sequence:
– For settings from 1-59 minutes, the display will
count down each second.
– For settings 1 hour or over, the display will
count down hours and minutes.
Oven selector
pads
(pp. 14, 19)
Electronic
display
Temperature
pads
(pp. 14, 17, 19)
Clock
pad
(p. 12)
Minute
timer set
and off
pads
(pp. 12, 13)
Oven
light
pad
(p. 29)
Using the control lock
The control lock lets you shut down the control
panel command pads. The control lock comes in
handy when you want to prevent others from
using the oven.
NOTES:
•
You can only use the control lock when the oven
is not in use or the control has not been set.
•
Set the control lock when cleaning the control
panel to prevent yourself from accidentally turning
on the oven.
•
The control lock will stay on even after a power
failure.
To lock the control panel:
Press and hold the start/enter pad for 5 seconds.
You will hear a single tone and “Loc” and
“LOCK’D” will appear on the temperature
display.
To unlock the control panel:
Press and hold the start/enter pad for 5 seconds.
You will hear 3 tones followed by a single
tone. “Loc” and “LOCK’D” will disappear
from the temperature display.
START
ENTER
5 SEC
START
ENTER
5 SEC
USING YOUR RANGE