Filter
Top Products
.____~
-_----
PROBLEM
Burner fails to
light
POSSIBLE CAUSE
SOLUTION
The power cord is not
Plug the power cord into a live circuit
plugged into a live circuit with
with proper voltage. (See Installation
proper voltage. Instructions.)
A household fuse has blown Replace household fuse or reset
or a circuit breaker has circuit breaker. In case of prolonged
tripped. power failure, manually light burners
(see page 8).
Burner ports are clogged.
Clean with a straight pin (see pages
24 and 26).
Burner flames
are uneven
Burner ports are clogged.
Clean with a straight pin (see pages
24 and 26). If this fails, call an
authorized Whirlpool@ service techni-
cian for service.
Burner flames
Air/gas mixture is incorrect.
Contact an authorized Whirlpool
lift off ports, are
service technician to check air/gas
yellow, or are
mixture.
noisy when
turned off
Burner makes
Burner is wet from washing. Let dry.
rhgi”o”, noise
Control knob(s)
You are not pushing in before
Push control knob(s) in before turning
will not turn
turning.
to a setting.
Self-Cleaning
The Oven Selector and Oven
Set both the Oven Selector and Oven
cycle will not
Temperature Control are not
Temperature Control to CLEAN.
operate
set to CLEAN.
The range clock does not Reset clock to show the correct time
show the correct time of day.
of day. (See page 11.)
The Lock Lever is not in the
Move Lock Lever all the way to the
CLEAN
position-all the way
right.
to the right.
The Start Time Dial does not
Reset the Start Time Knob to show
show the correct time of day
the correct time of day. Pull knob out
or the knob is not all the way
all the way.
out.
The Stop Time Dial is not set
See Step 3 in “Setting the controls”
ahead to the time you want
on page 21 for proper setting instruc-
the self-cleaning cycle to stop.
tions.
_.
’ on
next
page
29