Filter
Top Products
Surface Burners
Lift up the cooktop, following the instructions on page14.
Wipe off surface burners with warm soapy water and a soft cloth after each use.
Occasionally check surface burner flames for size and shape as shown. If flames
do not burn properly, you may need to remove the surface burners for cleaning
(see pageM), or call a qualified technician for burner adjustments.
For models SF5340ER, SF514OSR/ER and SF514ESR/ER; to adJust the
HI and LO sefflngs on the control knobs:
1.
Turn on the surface burners, then set the controls to LO.
2. Wlthout changing the burner sefflngs, remove the control knobs.
3. Firmly grasp the control stem and insert a small bladed screwdriver into
the end of the stem. Turn the screwdriver in either direction until the flame
height is Ye in (.318 cm] or lower in size. Flame must be large enough to
malntaln a STABLE FLAME on all burner ports.
NEVER ADJUST THE FLAME SIZE AT THE MEDIUM SEITING.
The Oven Door
Removing the oven door will make it easier to clean the oven.
Open the door to the first stop
position.
2. Hold the door at both sides and lift
off of hinges at bottom corners of
door.
3. To replace, fit the bottom corners
of the door over the ends of the
hinges.
Push the door down evenly. The
door will close only when it is on
the hinges correctly