Filter
Top Products
u
*
Electrical Shock Hazard
Unplug the refrigerator before removing a
light bulb.
Failure to do so can result in death or
electrical shock.
Your refrigerator has several light bulbs. This sec-
tion shows you where they are located and tells you
how to change them if they burn out. Before you
change any light bulb in your refrigerator, be sure to
turn the Refrigerator Control to OFF and unplug the
refrigerator. After you have replaced the bulb, plug
the refrigerator in and reset the Refrigerator Control
to the desired setting.
NOTE: Not all commercial appliance bulbs will fit
your refrigerator. Be sure to replace the bulb with
one of the same size and shape.
To change the refrigerator light:
1. Reach behind the Control Panel and remove
the bulb.
2. Replace the bulb with a 40-watt appliance bulb.
To change the crisper light
1.
Pull the top of the light shield forward until
it snaps free and lower until the light bulb
is visible.
2. Replace the bulb with a 40-watt appliance bulb.
3. Pull the top of the light shield up over the bulb
and snap it onto the side wall supports.
NOTE: To remove light shield for cleaning, remove
the crisper and the crisper cover. Then release the
bottom of the shield from the lower side wall
supports. Pull the light shield out from above the
crisper cover and wash it with warm water and a
liquid detergent. Dry the cover and replace it in the
reverse order.