Filter
Top Products
16
GETTING TO KNOW YOUR MICROWAVE OVEN
Audible signals
Audible signals are available to guide you
when setting and using your oven:
• A programming tone will sound each
time you touch a pad.
• One long tone signals the end of a Minute
Timer countdown.
• Four tones signal the end of a cooking
cycle.
• Two tones sound once every minute after
an End-of-Cooking signal as a reminder if
food has not been removed from oven.
• Three tones sound if you have made an
incorrect entry.
To disable all audible signals:
• Touch and hold Number pad 1 for 4
seconds to disable all programming tones.
To turn all signals back on:
Repeat step under “To disable all audible
signals” above.
NOTE: Three tones, followed by two tones,
will sound when audible signals are turned
on or off. The three tones will be omitted if
all tones are disabled.
Interrupting cooking
You can stop the oven during a cycle by
opening the door. The oven stops heating
and the fan stops, but the light stays on.
To restart cooking, close the door and
TOUCH
START
ENTER
OFF
CANCEL
If you do not want to continue cooking:
• Close the door and the light goes off.
OR
• TOUCH
Using the child lock
The Child Lock locks the control panel so
children cannot use the microwave oven
when you do not want them to.
To lock the control panel:
Touch and hold START/ENTER for
4 seconds. Three tones, followed by
2 tones, will sound and “LOC” will appear
on the display.
To unlock the control panel:
Touch and hold START/ENTER for
4 seconds. Two tones will sound and
“LOC” will be cleared from the display.
Using the demo/learning
feature
You can see your microwave oven’s
functions without turning the oven on.
NOTE: This feature can only be used when
the microwave oven is first connected to
power. You cannot use the demo/learning
feature after a Command pad has been
touched.
To set the demo/learning feature:
1. Open the door and keep it open.
2. Touch and hold Number pad 0 for
4 seconds. Three tones, followed by
two tones, will sound.
3. Release Number pad 0.
4. Shut the door to start the demo/learning
feature.
To cancel the demo/learning feature:
Touch OFF/CANCEL.
4359626.pm6 9/29/98, 2:43 PM16