Filter
Top Products
6. CHECKING THE MAIN OVEN CONTROLS
To set the clock (See Fig.10).
1 Turn on electricity supply and ensure that the thermostat is in the off position.
2 Rotate left hand clock knob to the position.
3 Set the time of day by rotating the right hand knob.
NOTE: that it is a 24 hour clock.
4 Rotate the left hand knob to the 'manual' position.
7. CHECKING THE MAIN OVEN
1 Set the clock as described in section 6, the clock is now ready for manual operation.
2 Turn the main thermostat knob to Mk. 9 and check that there is sparking from the ignition system. This
should continue until the oven burner is alight.
3 When the oven burner lights up the sparking should cease, there should be a low gas rate at first to the
oven burner which is the flame supervision device (F.S.D.) by pass rate.
4 When the F.S.D. phial has heated up it opens the F.S.D. valve and the main gas stream flows to the
burner.
5 Set the oven thermostat to Mk. 2, close the oven door and check that after 10 minutes the flame size has
reduced.
6 Turn off the thermostat and check that the oven flames go out.
8. AUTOMATIC OPERATION
Having set the clock up as described above, turn the left hand knob to the 'Cook Time' position and set the
right hand knob to show a cooking time of two minutes (0.02).
Turn the left hand knob to the 'End Time' position, the time shown on the display is now the time of day with
two minutes added on. Rotate the right hand knob to add two minutes to this time to give a two minute delay.
Turn the left hand knob to the 'Automatic' position to complete the programming sequence, the clock now
shows the time of day again with the auto neon glowing continuously.
Turn the oven thermostat on and two minutes after setting, the oven burner should commence it's lighting
sequence.
Two minutes after the lighting sequence has started the timer should switch off the gas supply to the oven
burner and the audible signal should sound. If the signal is continuous it may be switched off at any time by
rotating the left hand knob.
Return timer to manual by rotating the left hand knob to the 'manual' position.
GENERAL NOTE Instruct the user how to use the appliance. Inform the user that when the appliance is
first turned on they may be able to smell residues from the surfaces being burnt off. It may be necessary to
open a window for ventilation. The smell will disappear after using the oven a few times. Refer the user to the
wording in the inside cover of the Users Instructions which gives advice on the safe operation of the appliance.
Advise the user that the cooling fan may continue to work after they have turned off the oven or grill and it will
switch itself off when the oven has cooled down.
45
Fig.10