Filter
Top Products
30
Installation
– Cut out the side walls of the niche according to dra-
wing (fig.1). This is necessary for the diving–in of
the door when it is being opened.
– Attach the moulding to the side panels of the furni-
ture as described in the assembly sketch.
– Mounting of the door laminate to the door accor-
ding to separate drilling template.
– Place the appliance in front of the high cupboard,
and run the cable and hoses through the high cup-
board’s bay so that they are neither kinked or
squashed.
Run the cable and hoses through the high cup-
board’s bay so that they are neither kinked or
squashed.
– Align the dishwasher in the centre of the bay and
flush with the side panels, and where necessary,
adjust to be flush at the front surface using shims.
– Carefully open the door of the appliance without
changing the settings of the appliance.
– Using the pre–drilled holes, fix the spacers and
screw the appliance to the side panels of the furni-
ture on both sides in the upper inner area (see fig.
2).
– Fix the appliance laterally by means of the fixing
angles (AN) and screw it on to the wall of the niche
with screws (VI). It is advisable to protect the ap-
pliance door from damage using suitable materials
(e.g. the cardboard packaging). In order to tighten
these screws, the door must be opened by approx.
45 degrees. The appliance can be fixed to the fi-
xing angles from below with two screws M5x30 as
well (see fig. 3).
Technical data
Dimensions
Height 75.9 cm
Depth 57.0 cm
Width 54.6 cm
Capacity 11 place settings
Electrical connection 230–240V – 50Hz
Motor rating during wash 140 W
Power of heating element 2000 W
Overall power 2150 W
Water supply pressure Minimum 1bar
Maximum 10 bar
fig.1
C: fix
spacers
B: moulding
A: cut flank
fig. 2
side
walls of
cabinet
moulding
spacer
fig.3
fixing at
the bottom
left / right
distance flexible from 520 to 550
from 541 to 572
approx. diam. 6,4