xStack
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
350
The IP-MAC-Port Binding (IMPB) commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
config address_binding ip_mac ports [<portlist> | all ] { state [enable {[strict | loose] | [ipv6 | all ]} | disable {[ ipv6 | all ]}]
| allow_zeroip [enable | disable] | forward_dhcppkt [enable | disable] | mode [arp
| acl ] | stop_learning_threshold<int 0-500>} (1)
create address_binding ip_mac [ipaddress < ipaddr > | ipv6address <ipv6addr>] mac_address < macaddr > {
ports [ portlist | all]}
delete address_binding [ip_mac [[ipaddress < ipaddr > | ipv6address <ipv6addr>] mac_address <
macaddr > | all] | blocked [ all | vlan_name < vlan_name > mac_address <
macaddr >]]
config address_binding ip_mac [ipaddress < ipaddr > | ipv6address <ipv6addr>] mac_address < macaddr >
{ports [ portlist | all]}
show address_binding {[ip_mac [all | [ipaddress <ipaddr> | ipv6address <ipv6addr>] mac_address
<macaddr>] | blocked [all | vlan_name <vlan_name> mac_address <macaddr>] |
ports {<portlist>}]}
enable address_binding dhcp_snoop {[ipv6 | all]}
disable address_binding dhcp_snoop {[ipv6 | all]}
clear address_binding dhcp_snoop
binding_entry ports
[ <portlist>|all ] {[ipv6 | all]}
show
address_binding dhcp_snoop {[max_entry { ports <portlist>} | binding_entry {port <port>}]}
config address_binding dhcp_snoop
max_entry ports
[<portlist> | all] limit [<value 1-50> | no_limit]
enable address_binding trap_log
disable address_binding trap_log
config address_binding
recover_learning ports
[<portlist> | all]
enable address_binding nd_snoop
disable address_binding nd_snoop
show address_binding nd_snoop
show address_binding nd_snoop
binding_entry
{port <port>}
clear address_binding nd_snoop
binding_entry ports
[<portlist> | all]
debug address_binding [event | dhcp | all]
no debug address_binding
Each command is listed, in detail, in the following sections.
config address_binding ip_mac ports
Purpose Used to configure the state of IMPB on the switch for each port.
Syntax
config address_binding ip_mac ports [<portlist> | all ] { state [enable {[strict | loose] |
[ipv6 | all ]} | disable {[ ipv6 | all ]}] | allow_zeroip [enable | disable] | forward_dhcppkt
[enable | disable] | mode [arp | acl ] | stop_learning_threshold<int 0-500>} (1)
Description Used to configure the per port state of IMPB on the switch.
If a port has been configured as group member of an aggregated link, then the IMPB function
