GPSMAP
®
4000/5000 Series Owner’s Manual 47
Almanac, Environmental, and On-boat Data
On-boat Data
Engine and Fuel Gauges
Viewing Engine Gauges
You must be connected to a NMEA 2000 network capable of sensing engine data to view engine gauges. See
the GPSMAP 4000/5000 Series Installation Instructions for details.
From the Home screen, select > .
Cycling Through Engine and Fuel Gauge Screens
1. From the Home screen, select > .
2. Move from one gauge screen to the next:
• For the GPSMAP 4000 series, use the .
• For the GPSMAP 5000 series, select the left and right arrows at the top of the page.
The chartplotter shows the next engine gauge or fuel gauge screen.
3. Repeat step 2 to cycle through all the engine gauge and fuel gauge screens.
Customizing Engine and Fuel Gauge Limits
You can congure up to four values for each engine gauge or fuel gauge, to establish the upper and lower
limits of the gauge and the range of desired standard operation. When a value exceeds the range of standard
operation, the gauge face or bar becomes red.
Setting Description
Scale minimum This value is less than the rated minimum, and it represents the lower limit of the gauge�
This setting is not available on all gauges�
Scale maximum This value is greater than the rated maximum, and it represents the upper limit of the
gauge� This setting is not available on all gauges�
Rated minimum Represents the minimum value of the standard operating range�
Rated maximum Represents the maximum value of the standard operating range�
1. From the Home screen, select > > > > .
2. Select a gauge.
3. Select > .
4. Select the gauge limit you want to set (, , , or ).
5. Select .
6. Select the desired limit from the list.
7. Repeat steps 4 through 6 to set additional gauge limits.
Activating Status Alarms for Engine Gauges and Fuel Gauges
If you have activated gauge status alarms, when the engine sends a warning state message over the NMEA
2000 network, a gauge status alarm message appears. The gauge face or bar may become red depending on the
alarm type.
From the Home screen, select > > > > >.
Customizing Engine and Fuel Gauge Status Alarms
1. From the Home screen, select > > > > >
.
2. Select one or more engine gauge or fuel gauge alarms that you want to turn on or off.
3. Select .
