Kodak I1400 Manual

A SERVICE OF

next previous

A-61550 February 2010 5-13

Replacing the pre-

separation pad

1. Remove the separator module as previously directed.

2. Locate the pre-separation pad on the separator module.

3. Hold the separator module in both hands and find the two pre-

separation pad side tabs which protrude slightly from the back of the

separator module.

4. Push on the pre-separation pad side tabs on the back until the pre-

separation pad protrudes slightly from the front of the separator

module.

5. Grasp the pre-separation pad and pull it out of the separator

module.

6. Discard the worn pre-separation pad.

7. Align the side tabs of a new pre-separation pad with the slots on the

separator module.

8. Push the pre-separation pad firmly in the slots until the pre-

separation pad flap rests lightly against the separator module tires.

9. Reinstall the separator module.

10.Close the scanner cover with both hands; push it down firmly until it

latches into place.