A SERVICE OF

logo

Open as PDF
next previous
5-4 A-61550 February 2010
Cleaning the
separator module
1. Push up on the scanner cover release latch and open the scanner
cover.
2. Lift the separator module up and out of position.
3. Manually rotate and wipe the separator module tires with a roller
cleaning pad.
4. Inspect the tires. If the separator module tires show signs of wear or
damage, replace the tires or the separator module. See the section
entitled, “Replacing the separator module and separator module
tires” later in this chapter.
5. Insert the separator module and align the shaft ends.
6. Press until the separator module clicks into place.