106 Settings | Control Panel Options
MX7 Reference Guide E-EQ-MX7RG-B
Password
Access: | Settings | Control Panel | Password Icon
Set MX7 user access/power up password properties. Password and password settings are saved
during a warm boot and a cold boot. The screensaver password affects the Remote Desktop
screensaver only.
Factory Default Settings
Password Blank
Enter at Power On Disabled
Enter at Screen Saver Disabled
Note: Once a password is assigned, each Settings option requires the password be entered
before each Settings option can be accessed.
Figure 3-21 Password
Enter the password in the Password textbox, then type it again to confirm it.
Enable the power-on checkbox and, if desired, the screensaver checkbox. Tap the OK button to
save the changes. The password is in effect immediately.
The screensaver password is the same as the power-on password. They are not set independently.
A screensaver password cannot be created without first enabling the “Enable password protection
at power-on” checkbox. The screensaver password is not automatically enabled when the “power-
on” checkbox is enabled.
Troubleshooting
The password must be entered before performing a coldboot or cold reset. If entering a power-on
or screensaver password will not allow you to disable password protection or run COLDBOOT,
contact LXE Technical Support.
