10
INTRODUCTION
Rear
Controls & Connectors
Front
Enter Button
Control Buttons
Up, down, right and left buttons are
used to enter adjustments and settings
when using the ScreenManager menu.
Auto Adjustment Button
Automatically centers the displayed image
and adjust Clock and phase.
Input Signal Selection Button
Selects one of two D-Sub connectors as the active input.
Power Button
Switches the monitor’s power ON and
OFF only when the main power is ON.
Power Indicator
Indicates the power-on status in the
following ways:
Green (Solid): Power is ON
(Flashing): Power is switching
off in 15 minutes
(See page 32.)
Yellow (Solid): Power Saving Mode
(Flashing): Power is OFF
(Main power’s ON.)
Power
Terminal
Covers for
the Optional
peripheral
4 Holes for Mounting an Arm-Stand
Security Lock
Allows for connection of a security cable.
This lock supports the Kensington’s
MicroSaver security system. For further
information, please consult below:
Kensington Technology Group
2855 Campus Drive, San Mateo, CA
94403 USA
800-650-4242, x3348
Intl: 650-572-2700, x3348
Fax: 650-572-9675
http://www.kensington.com
Power
Connector
Maintenance Port
Service use only.
USB Ports (Upstream Port x 1)
On USB ports, see page 34 for further details.
USB Ports
(Downstream Port x 4)
2 x D-Sub mini 15 pin Input Connectors
Power
Switch
